Mustang MonthlyHow To Drivetrain
Ford Mustang Clutch Service - How To Service And Adjust Mustang Clutches
Take The Mystery Out Of Getting A Smooth Upshift
Proper clutch adjustment is the key to clutch survival and proper operation. As clutches wear or are replaced, they require adjustment.
Adjustment begins with what you feel and hear. With the engine running, slowly step on the clutch pedal. Take note of when you can feel the vibration of the engine's rotation through the pedal. The point between touching the pedal and feeling engine rpm is called free travel. That's the time when nothing happens, right before clutch release-bearing contact. When there is a problem with free travel, the adjustment rod needs to be changed to get it within specs.
Although Ford has an involved approach to clutch adjustment, we're more seat-of-the-pants about it. There's an easier way. Clutch adjustment boils down to feel and preference. It should never be adjusted where the release bearing-also called a throwout bearing-is constantly touching the clutch fingers or diaphragm. This will cause premature wear and failure. Turn the clutch-rod adjustment to where pedal free travel is a minimum of 7/8 inch for the '65, or 1/2 inch for model years '66-'73. You want a maximum of 1 1/8-inches of free travel. The amount you come up with depends on what's comfortable to you.
For '65 and early '66 models, clutch adjustment is at the pushrod coming through the firewall. Adjust the equalizer bar fore or aft to get 7/8- to 1 1/8-inches of free travel. With each adjustment, raise engine speed to 2,000 rpm. If you can feel the engine just touching the pedal, free travel isn't enough. That's when you must back the adjustment off to get the release bearing out of the clutch fingers/diaphragm.
Beginning in the '66 model year, Ford revised the clutch release linkage, moving adjustment to the clutch fork, where it stayed through 1973. The same situation applies here: adjust the rod tighter to reduce, or looser to increase free travel.
Once the adjustment is made, work the clutch several times with the engine running, then see how much free travel you have. Remember, the amount you have is a personal preference. Some don't like much, while others like it sloppy. Ford's limits apply in all cases.
Quick Clutch Tech
There are three basic kinds of clutches: Borg & Beck, long, and diaphragm. We're inclined to add a fourth: Centerforce, a diaphragm-style clutch that grips better with rpm. Flyweights tied to the diaphragm increase grip with engine rpm and is a great innovation in clutch design. This is basically the only clutch we ever use.
Three-finger Borg & Beck and long-style clutches are more traditional designs. They work well, but are hard on clutch-release linkage. Although they were original equipment, they aren't the best for a classic Mustang.
Clutch Linkage Identification
When we headed to Mustangs, Etc. to learn all we could about clutch release mechanisms, we thought it would be a simple task. It wasn't. Not only was there an equalizer shaft for each type of engine, but also engineering changes from year to year. Ford struggled with warranty issues and customer criticisms regarding clutches. With each crop of complaints, the company went back to the drawing board and made changes in design.