Installing Classic Ford Mustang Fog Lights - How To Install GT Foglights

4. Reassemble the foglight housings with the lamps installed, and assemble them to the bars using the studs on the rear housings.

5. Secure the bars to the housings with the nuts. Be sure to use the special washer between the housing and nut.

6. Attach the assembled bars to the running-horse corral. A new corral is supplied with the kits for '66 Mustangs; the existing corral is used for '65 Mustangs.

7. Install the mounting studs, four in the corral and one in each of the lightbars.

8. Merv Rego from Classic Creations of Central Florida shows the assembled foglights, which are ready to mount on the '66 grille.

9. Unbolt the grille and remove it from the car.

10. With the grille on the workbench, remove the four nuts that retain the non-GT running-horse corral and remove the corral. On '66 Mustangs, the foglight corral is different from the standard corral due to the ears for mounting the lightbars.

11. Install the foglight brackets at each end of the grille using the supplied screws. Note that the holes for the '66 brackets are already in the grille edges, two at the top and one at the bottom. Don't tighten the screws at this point because the brackets will likely require adjusting.

12. Route the foglight wiring through the large opening in each bracket, then mount the foglight assembly to the grille using the four studs in the corral and one stud on each lightbar. Now you can tighten the bracket screws.