 These powerful speakers have...  These powerful speakers have a full chrome basket, 200 watts of peak power capacity, 063mm Ferrite tweeters, 036mm Neodymium tweeters, 4-ohm impedance, and 16-ounce magnets. They utilize a durable synthetic material that will outlast those old Kraco speakers from the 1970s. |  We're removing this Mustang's...  We're removing this Mustang's old Kenwood auto-reverse AM/FM cassette system from the 1980s. As you can see, the bezel has been modified to accommodate the Kenwood. We won't have to do that with Custom Autosound's USA-630. |  We're using the old bezel...  We're using the old bezel for mock-up purposes. The stereo face adaptor slides into place as shown. This gets the USA-630 flush with the bezel. |
 Custom Autosound provides...  Custom Autosound provides metal and plastic spacers that fit between the stereo and bezel for solid positioning. Stack them as you wish to achieve proper unit depth. |  There are two basic wiring...  There are two basic wiring bundles-power and speakers. The power circuit has two fuse-protected power sources from the ignition switch and from uninterrupted power (orange) for the clock and radio settings. |  Switched power (red) provides...  Switched power (red) provides power to run the unit. Black is the ground lead. The transformer controls needed unit voltage, typically less than the 12-14-volts from the battery. |
 We like this quick-disconnect...  We like this quick-disconnect multiplex plug that enables quick removal for any service. Pull this guy and the antenna lead and you're good to go. |  This wire bundle consisting...  This wire bundle consisting of greens, blues, and whites is your USA-630's speaker leads, which are all labeled for easy installation. The yellow lead is for power antenna. |  This is the USA-630's antenna...  This is the USA-630's antenna lead. Custom Autosound also provides an extension in case your antenna lead is too short. |
 Unit installation is easy...  Unit installation is easy once you've established proper unit to bezel spacing. Custom Autosound provides a strap that ties to the dashboard where the original AM radio support was. |  Use bullet connectors to connect...  Use bullet connectors to connect the speaker leads. |  Along with the vintage Kenwood...  Along with the vintage Kenwood cassette deck, we trashed these old speakers. The hacked up package shelf structure had to be repaired and prepped for the Custom Autosound speaker installation. |
 The new SPUV693C speakers...  The new SPUV693C speakers are installed from underneath using stainless, fine-thread Phillips screws and lock nuts. |  Black powdercoated speaker...  Black powdercoated speaker grilles will not distort in the sun. | |